Installing 2 other drivers
Posted: Sat May 11, 2013 1:18 pm
Hi!
I'm just starting to use Actual Installer 4.8, so the answer to my question maybe trivial.
Requirements
I need to run 2 additional installations as part of the installation of the application I'm packaging:
1. Crystal Reports runtime file for VS2010
2. Silicon Labs cp210x driver
I would like to give the user an option to decide whether the installation of these additional s/w is needed.
Problem
However:
- Only one action can be defined in Dialogs\Finish tab.
- Defining the 2 installations as commands in System\Command fails as the /WAIT does not work (maybe these installations do not return a value?); also - if the user cancels the first installation, the second one is not run.
Any suggestion will be much appreciated,
Amir
I'm just starting to use Actual Installer 4.8, so the answer to my question maybe trivial.
Requirements
I need to run 2 additional installations as part of the installation of the application I'm packaging:
1. Crystal Reports runtime file for VS2010
2. Silicon Labs cp210x driver
I would like to give the user an option to decide whether the installation of these additional s/w is needed.
Problem
However:
- Only one action can be defined in Dialogs\Finish tab.
- Defining the 2 installations as commands in System\Command fails as the /WAIT does not work (maybe these installations do not return a value?); also - if the user cancels the first installation, the second one is not run.
Any suggestion will be much appreciated,
Amir