I have several commands in the installation but non of them are running.
One of them is the following
Command: <SystemDir>\cmd.exe
Parameters: /C del <InstallDir>\dotNetFx40_Full_x86_x64.exe
Launch on: All
Show: Hide
Launch: After Install
Wait until process finishes is checked.
The installer is putting the file in the the <InstallDir> but it will not run the command to execute the file nor the command to delete the file.
Please help
Tim
Commands not running
Re: Commands not running
Hi Tim,
Try the following:
Parameters: /C del /Q "<InstallDir>\dotNetFx40_Full_x86_x64.exe"
Try the following:
Parameters: /C del /Q "<InstallDir>\dotNetFx40_Full_x86_x64.exe"