Bug in new release
Posted: Tue Sep 10, 2013 11:29 pm
I recieved an email notifying me that I could download and install 5.0 - I had been using 4.5
After I did the download and install, I encountered two problems:
The readme document was not displayed when I tested the install.
The license document was not displayed when I tested the install.
Both documents were specified under their respective tabs.
Both document references were "grayed out".
The "Edit" and "specify" buttons were grayed out (disabled).
The "Clear" button was active but instead of clearing anything when clicked, it displayed a message box asking me to "Please select a language".
Something is seriously screwed up - is there a correction available???
After I did the download and install, I encountered two problems:
The readme document was not displayed when I tested the install.
The license document was not displayed when I tested the install.
Both documents were specified under their respective tabs.
Both document references were "grayed out".
The "Edit" and "specify" buttons were grayed out (disabled).
The "Clear" button was active but instead of clearing anything when clicked, it displayed a message box asking me to "Please select a language".
Something is seriously screwed up - is there a correction available???